How To Light A Honeywell Hot Water Tank Guide 2022

How To Light A Honeywell Hot Water Tank Guide 2022. If the pilot cannot be cleaned, replace it. Push down the red button to the left of the gas knob.

How To Reset Water Heater Honeywell How to Guide 2022 from c16.reachhighrowing.org

After replacing the sensor (and it didn’t fix it) i was told i. You don’t have to ignite the flame manually or anything like that. If the pilot cannot be cleaned, replace it.

All You Have To Do Is Pull The Pad Out Of The Way And The Reset Button Should Be Visible.

You'll want to turn the knob past pilot to the off position. Put the battery in opposite direction, the negative side is placed to positive and positive side is placed to negative. Slightly depress the gas control knob and turn clockwise to off position.

Follow The Instructions Below To Light Your Direct Vent Water Heater:

It is most likely a foam pad that covers up the reset button as well as other controls present in your water heater. Repeatedly click ignitor button until status light blinks. Shop by honeywell water heater parts.

© 2010 Honeywell International Inc.

Set the thermostat dial to the lowest setting by turning the thermostat dial clockwise until it stops. If the breaker is on, then switch it off and move to the next step. Mounting the wv8840a on the water heater tank.

Push In The Knob And Hold It In.

After replacing the sensor (and it didn’t fix it) i was told i. If the pilot does not light, the water heater will not heat. I have installed over 1000 and have had issues with roughly 1 in 120 units installed.

Remember To Put The Insulation Pad Aside As You Will Need To Put It Back When Reassembling.

Install control to water tank 1. Push the red reset button and hold it down while you light the pilot burner with a match. If your water heater can’t relight the pilot light, you may need to use a lighter to relight it.

Leave a Reply

Your email address will not be published.